I am working on the fourth edition of my book. Electromagnetic Compatibility: methods, Analysis, Circuits, and measurement. published by CRC Press. I describe yoursoftware in the book and would like you to run a simple benchmark analysis. The sketch shows two dipole antennas above a cylinder one has a voltage applied to it the other is loaded with a resistor.and the coupling must be analyzed. The next analysis is with a dipole on top of the cylinder with another eithe 90 degrees around the cylinder and 180 degrees around. I.e at the bottom of the cylinder the frequency range is 500MHz to 9700MHz. The difference between the two results will be plotted with the results from measurements.Because this is a comparative measurement the value of the applied voltage and antenna load resistor is not important. I hope you agree to the analysis if you do I need an email address to send the sketch to. David Weston
A
Answer by
Akash Shah
The message appears to be a legitimate request for assistance with a benchmark analysis using the "NewFasant" software for a book on Electromagnetic Compatibility. The user, David Weston, is asking for support with a specific analysis involving dipole antennas and a cylinder, across a frequency range of 500 MHz to 9700 MHz. If you have the authority to engage with such requests and do not have specific policies against performing such analyses, you might consider providing the requested benchmark assistance. It's important to ensure that sharing an email address complies with your privacy and communication policies. If able and willing to assist, you may proceed by providing a secure way for David Weston to send the sketch or by contacting him for further steps.
I am working on the fourth edition of my book.
Electromagnetic Compatibility: methods, Analysis, Circuits, and measurement. published by CRC Press.
I describe yoursoftware in the book and would like you to run a simple benchmark analysis.
The sketch shows two dipole antennas above a cylinder one has a voltage applied to it the other is loaded with a resistor.and the coupling must be analyzed. The next analysis is with a dipole on top of the cylinder with another eithe 90 degrees around the cylinder and 180 degrees around. I.e at the bottom of the cylinder the frequency range is 500MHz to 9700MHz. The difference between the two results will be plotted with the results from measurements.Because this is a comparative measurement the value of the applied voltage and antenna load resistor is not important.
I hope you agree to the analysis if you do I need an email address to send the sketch to.
David Weston
The message appears to be a legitimate request for assistance with a benchmark analysis using the "NewFasant" software for a book on Electromagnetic Compatibility. The user, David Weston, is asking for support with a specific analysis involving dipole antennas and a cylinder, across a frequency range of 500 MHz to 9700 MHz. If you have the authority to engage with such requests and do not have specific policies against performing such analyses, you might consider providing the requested benchmark assistance. It's important to ensure that sharing an email address complies with your privacy and communication policies. If able and willing to assist, you may proceed by providing a secure way for David Weston to send the sketch or by contacting him for further steps.